|
HD-Cleanse
| Strik
| Fabrique
The second step to protecting your car's finish is to remove any
dead, oxidized paint. HD-Cleanse removes light oxidation, moderate
scratches, accumulated road film, tar and acid rain deposits, renewing
your original paint luster.
Zymol HD-Cleanse
Paintwork Cleaner
Directions for Use:
- Using a clean HD-Cleanse applicator
or a small terrycloth towel, apply HD-Cleanse evenly but
liberally onto a three or four square foot section with a straight-line,
side-to-side movement.
NOTE: Do not use a circular motion when spreading HD-Cleanse.
- Work HD-Cleanse into the
finish with a medium to heavy pressure until the surface becomes
tacky.
- Gently buff with a clean Zymol towel
to reveal the true, clean finish of your car (the paint squeaks).
Important: Do not drive the car or allow it to stand more than 24
hours without completing the Zymol process. (See Feeding).
Contains Montan
Oil, Apricot Kernel Oil, Lemon Seed Oil, Coconut Oil, Cetyl Esters,
Cetyl Cocomide (derived from coconut oil), Cocoamide, Citric Acid
(from rose hips), Kapolite.
Top
Zymol Strik
Cosmoline Remover
Directions for Use:
- Pour Zymol Strik to the line marked
"1" on the side of the Zymol spray bottle.
- Add the amount of water to desired
concentration.
- Swirl slightly to mix.
- Spray Zymol Strik evenly over cool,
dry metal surfaces and let stand for two to three minutes.
- Brush gently with a Zymol brush.
- Rinse thoroughly
NOTE: Do not use brushes on exterior paint work. Paint can be
damaged by scrubbing. Rinse off all loose dirt and silt before
using.
Contains Lemon
Rind Oil, Grapefruit Rind Oil, Citric Turpine, Cetyl Cocoamide (derived
from coconut oil), Cocoamide, Spun Tallow and Castile Soaps.
Top
Zymol Fabrique
Cloth Cleaner
Directions for Use:
- Pour Fabrique to the line marked
"1" on the side of the Zymol spray bottle.
- Mix the correct amount of seltzer
water (low/no sodium CO2-charged water) according to the label
on the side of the bottle to your desired strength.
NOTE: The label is marked in concentrations of 1, 1:1, 1:2,
and 1:3
- Swirl slightly to mix.
- Spray Fabrique evenly. Let
stand for one or two minutes.
- Brush gently with a Zymol detail
brush or a soft clean cloth.
- Vacuum thoroughly to a dry finish.
NOTE: Do not soak any surface. Fabric can be damaged by too
much moisture.
Contains Synthesized
(spun) Tallow Soaps, Cetyl Esters, Cetyl Cocoamide (derived from
coconut oil), Parsley Extract, Chlorophyl, Citric Acid (from rose
hips), FD&C Blue #1.
Top |
